KBox A-150-SKL - User Guide Rev. 1.1
// 28
6/
Accessing Components
This chapter contains important information that users must read before accessing components. Follow these
procedures properly when accessing or installing components.
Protection label
The KBox A-150-SKL is factory configured to meet customer requirements and then sealed
with a protection label. Opening the KBox A-150-SKL invalidates the warranty and may
damage internal components.
Before opening the KBox A-150-KBL, the product must be switched off using the power-on
switch, and disconnect all peripheral devices. Disconnect the product from the AC mains
power supply by removing the power cable from the DC power supply or the mains power
socket. Observe the General Safety Instructions for IT Equipment within this user guide.
ESD Sensitive
Follow the safety instructions for components that are sensitive to electrostatic discharge
(ESD). Failure to observe this warning notice may result in damage to the product or/and
internal components.
Pay attention to manufacturer’s instructions before installing/removing expansion cards.
Due to the limited predetermined lifespan of expansion devices, Kontron recommends that
users check on the condition of installed expansion devices regularly and pay attention to
the manufacturer’s lifespan specifications.
Accessing the 2.5” HDD/SSD Drive Bay
6.1.
To install or remove a 2.5” HDD/SSD drive (7 mm or 9.5 mm) in the 2.5 “HDD/SSD drive bay, perform the following:
1.
Close all applications. Shut down properly using the power-on switch and disconnect the power cable from the
DC main power supply.
2.
Slide the drive bay eject button to the left (Figure 11, pos. 2), to release the drive bay cover and gain access to the
drive bay. When released the drive bay cover flips open automatically. (Figure 11, pos. 3)
Figure 11: 2.5” HDD/SSD Drive Bay
1
Drive bay cover (closed)
2
Drive bay eject button
3
Drive bay cover (open)
4
Drive bay
3.
Remove an existing drive by holding the sides of the drive and carefully pulling the drive out of the drive bay.
2
1
4
3
