COMe-cEL6 - User Guide, Rev.1.3
// 29
2.4.3.2.
Single Power Supply Mode
To start the module in single power supply mode, connect VCC power and open PWR_OK at the high level. VCC can be
8.5 V to 20 V. To power on the module from S5 state, press the power button or reconnect VCC.
Suspend/Standby states are not supported in single power supply mode.
Table 9: Single Power Supply Mode Settings
State
PWRBTN#
PWR_OK
V5_Standby
VCC
G3
0V/x
[1]
0V/x
[1]
0V/x
[1]
0V/x
[1]
S5
high
open / high
open
VCC
S5
→
S0
PWRBTN Event
open / high
open
reconnecting VCC
G3
→
S0
high
open / high
open
connecting VCC
[1]
Defines that there is no difference if connected or open.
All ground pins must be connected to the carrier board’s ground plane
.
