Sandstrom SDW60GB13, Instruction Manual

Page: 26 / 36

26
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the
unit has dispensed the detergent or detergent tablet. This will depend on how long the
washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press and hold down the P programme button
for 3 seconds to cancel the programme. You can then select the required new programme
button and close the dishwasher door. The unit will start the new washing cycle shortly.
Adding An Extra Dish
If you need to add an extra dish, you can so so before the detergent cap opens.
1. Open the door a little to avoid waters spillage. Wait for the spray arms to stop spinning.
Open the door completely.
2. Add the extra dish(es).
3. Close the door.
4. The machine will automatically continue the wash cycle after 10 seconds.
The condensation strip helps prevent the risk of steam damage to the worktop edging above the
dishwasher. It is advisable to leave the door closed until you are ready to unload the crockery. Do not
leave the door only partially open. Do not leave the appliance unattended with the door fully open as this
could present a trip hazard.
At the End of a Programme
At the end of the programme, the dishwasher will beep.
1. The LED indicator will illuminate solidly. Open the door and press to turn off the machine.
The unit will beep.
2. Open the door carefully and fully, escaping steam and remaining water may scald.
3. Wait about 15 minutes before unloading the dishwasher (see the section, “Unloading the
Dishwasher”.)
LED Indicator Table
LED Colour Action Description
Blue Blinking • Wash programme in progress.
Blue Solid • Wash programme paused.
White (for SDW60GW13)
Green (for SDW60GB13)
Solid (with 3 beeps) • Wash programme is finished.
SDW60GW_B13_IB_Final131227.indd 26 27/12/2013 12:30 PM