Connection Details
Operation
IRIG-B TTL input is the source for this system. IRIG-B RS85 is the
output from this converter. The system has a BNC connector for
IRIG-B TTL input and a terminal for IRIG-B RS485 output. Terminal
block indicated with IRIG-B+ (Positive Signal) and IRIG-B-(Negative
Signal) of RS485 output. SIG LED indication is provided to know
the input signal from the IRIG-B source. Verify the Status LED after
connecting the Power Supply and IRIG-B input.
The System is an installation device. Installation and commissioning
may only be carried out by suitably qualified specialist personnel. In
doing so the respective country-specific specifications must be
observed
Before commissioning ensure that:
The power supply has been connected correctly and electrical
shock protection is in place
The earth wire is connected
All output cables are suitably sized
Sufficient convection is guaranteed
Note: The equipment may contain life-threatening components
and a high level of stored energy.
It will glow Red when the converter is powered ON.
It will go OFF when no power supply.
IIt will blink Green when IRIG-B input available.
It will go OFF when IRIG-B input not available.
POWER LED
SIG LED
IRIG-B RS 485
RELAY
+
--
Installation of the Enclosure
The System is assembled in a Wall Mountable Enclosure
The following steps are to be carried out:
Place the unit in the control panel and fix the mounting
brackets on the front side of the rack using Screws.
Ensure that there is sufficient space between the connection
side of the rack and the control panel to allow for the
connection of cables to the System.
Note:
At higher temperatures, active cooling/ventilation is
recommended.
AC Power Supply
Attention should be paid to the following when connecting the
power supply
Correct voltage type AC
Voltage level
The power feed is via a 3 pin phoenix combicon connector. The
phase should be connected to ‘L(+)’. Neutral should be Connected
to ‘N (-)’. Connect the input connector to the mains power supply
and switch the line circuit breaker ON.
Note: The System can be damaged if incorrect voltage is connected
DC Power Supply
Ensure that the external power supply is switched off. When
connecting the supply cable make sure that the polarity is correct
and the equipment is earthed. The power feed is via a 3pin phoenix
combicon connector. The positive pole should connect to ‘L (+)’. The
negative pole should be connected to ‘N (-)’. Connect the input
connector to the mains power supply and switch the line circuit
breaker ON.
Note: The System can be damaged if incorrect voltage is connected.
Safety and Warning Instruction
Please read these instructions fully in order to guarantee safe
operation of the equipment and to be able to use all the functions.
Caution: Never work on an open unit when voltage is applied!
Danger to life!
│
│
RIG-B TTL To RS485 Converter. 06/05/21
Summary of Contents for SLC-1010
Page 1: ...www sandsindia com...