S&P CRBB Series, Manual

Page: 3 / 12

1. SAFETY REGULATIONS AND NOTES
Thank you for placing your confidence in S&P by buying this product. It has been manufactured following current technical
safety regulations and in compliance with EC standard.
Please read this instruction booklet carefully before installing or starting up the product. It contains important information on
personal and user safety measures to be followed while installing, using and carrying out maintenance work on the equipment.
Once the product has been installed, please hand in this booklet to the end user.
Check that the device is in perfect condition while unpacking. Any fault or damage caused in origin is covered by the S&P
guarantee. Please make sure that the device
coincides with the product you have ordered and that the details on the instructions plate fulfil your requirements.
1.1. Staff qualification
The device may only be transported, unpacked, installed, operated, maintained and otherwise used by qualified, trained and
authorized technical staff.
Only authorized specialists are permitted to install the device, to carry out a test run and to perform work on the electrical
installation.
1.2. Basic safety rules

Any safety hazards stemming from the device must be re-evaluated once it is installed in the end device.

Do not make any modifications, additions or conversions to the device without the approval of S&P.
Once ready to use, the apparatus must fulfil the following standards:

Low Voltage Directive: 2006/95/CE

Machinery Directive: 2006/42/CE

Electromagnetic Compatibility Directive: 2004/108/CE.
1.3. Electrical voltage

Check the electrical equipment of the device at least every year.

Replace loose connections and defective cables immediately.
1.4. Rotating device
Long hair, loose items of clothing and jewellery could become entangled and pulled into the device. You could be
injured.
1.5. Hot surface
High temperature at the motor housing
Danger of burn injuries.
Ensure that sufficient protection against accidental contact is provided.
1.6. Transport and storage of the device

The packaging used for this device has been designed to support normal transporting conditions. The device must
always be transported in its original packaging as not doing so could deform or damage the product.

The product should be stored in a dry place in its original packaging, protected from dust and dirt until it is installed in
its final location. Do not accept delivery if the device is not in its original packaging or shows clear signs of having been
manipulated in any way.

Do not place heavy weights on the packed product and avoid knocking or dropping it.

When manipulating heavy products, adequate elevating machinery should be used to avoid harming people or
damaging the product itself.

Never lift a product by pulling it by the wires or terminal casing. Likewise, no pressure should be applied on the
propeller, turbine or safety grid while manipulating the product.
1.7. Disposal
In accordance with EEC Standards and our responsibility for future generations, we are obliged to recycle all the materials we
can. Therefore, please deposit all waste material and packaging in their corresponding recycling containers and hand in the
replaced units to the nearest handler of this type of waste product.
ENGLISH