19
ENGLISH
a plastic bags. Before switching on the unit, it is necessary to remove these bags and reas-
semble the fi lters, making sure that the air direction matches the one indicated in the fi lter
frame.
To remove the fi lter bags, follow the next procedure:
• Make sure that the unit is not connected to the electrical network.
• Use protective gloves when handling the appliance.
• Using the wrench supplied with the appliance, loosen and remove the screws that hold the
fi lter access cover (Fig. 1).
• Remove the cover (Fig. 2).
• Release the absolute fi lter by loosening the four existing rotary knobs (Fig.3-A). Remove
the absolute fi lter, take it out of its bag and return it to its position. Perform the same ope-
ration with activated carbon and VOC fi lters in case your unit incorporates them.
• Close the cover again, fi xing it with the corresponding screws.
CA/VOC filter
according
to version
F7 pre-filter
H14 filter
A
A
AIR
AIR
Fig. 1
Fig. 2
Fig. 3
When installing the new fi lters make sure that the air direction of the fi lter label matches
with the airfl ow in the unit.
Once the fi lters have been disbursed the unit is ready to be started up.
Connect the power cable to the electrical supply and press the on/off switch. Then adjust the
airfl ow according to the needs of the room (see next point).
9. AIRFLOW ADJUSTMENT
All models of the PAP range have a built-in potentiometer that allows the manual adjustment
of the fan speed.
The speed adjustment depends on various factors such as the room surface, height, the type
of use and its occupation.
Speed too low will cause the air quality in the room to be inadequate.
While speed too high will cause fouling of premature fi lters.
Below we show a series of tables with recommended speeds depending on the application
and the dimensions of the room.
Summary of Contents for AIRPUR PAP 350
Page 1: ...PAP 350 PAP 420 ES EN FR...
Page 2: ......