SSD (Formerly FFD) Ultra ATA 2.5"
13
Product Specification and User Manual
41-PS-0104-00 Rev. 2.3
Pin# 20 - Missing
44
43
2
50 48
1
49 47
Figure 3:
SSD Ultra ATA 2.5” Pin Configuration
3.4. Reliability - Mean Time Between Failures (MTBF)
The MTBF statistics for the SSD, described in Table 7, were calculated based on Telcordia
SR-332, GB, 25°C:
Table 7: MTBF for the SSD
2.5” Ultra ATA
Capacity
MTBF (Hours)
FIT (Failure Rate per Million Hours)
1GB
– 8GB, 16GB
1,485,397
0.6808
32GB
1,056,635
1.4037
48GB
871,839
1.1470
64GB
547,105
1.8278
80GB
601,214
1.6633
128GB
471,209
2.1222
A detailed report can be supplied upon request.
Note: The information in this section is relevant for SSD units with firmware version 1.15 and
later.
3.5. Error Detection/Correction Code (EDC/ECC)
The SSD has embedded error detection and error correction hardware and software mechanisms.
The EDC/ECC uses the BCH algorithm, which can detect up to 5 errors in 512 bytes of data, and
correct up to 4 errors.
3.6. Environmental Conditions
The SSD complies with the specified performance requirements after exposure to non-operating
environmental conditions, or during and after exposure to operating environmental conditions.
