S&C Instruction Sheet 1074-510
11
Description
To route traffic between subnets, several things must happen. First, all hosts on a
given subnet must use the attached SpeedNet ME Radio as their default gateway. As an
alternative, manual routes can be entered in each host’s routing table. Hosts from Subnet
1 will list 192.168.1.1 as their default gatew
ay. If AODV is disabled, and static routing is
used, it is necessary to add static routes in each SpeedNet ME Radio. The Sp
eedNet ME
Radio from Subnet 1 must have a static route to Subnet 2, using the SpeedNet ME Radio
from Subnet 2 as the gateway. The route should be set up like this:
192.168.2.0
255.255.255.0
192.168.3.2
Network
Netmask
Gateway
All hosts from Subnet 2 should use 192.168.2.1 as their default gateway. As an alterna-
tive, manual routes can be entered in each host’s routing table. The SpeedNet ME Radio
from Subnet 2 must have a static route to Subnet 1, using the SpeedNet ME Radio from
Subnet 1 as the gateway. This route should be set up like this:
192.168.1.0
255.255.255.0
192.168.3.1
Network
Netmask
Gateway
NOTICE
It is important to understand that there are actually three subnets in this example:
Subn
et 1, Subnet 2, and the radio network .
It is also important that all radio wireless IP addresses should be on the same
subnet, while all radio Ethernet IP addresses should be on different, non-overlapping
subnets .
Regulatory
Information
FCC Warning
T
his device must be professionally installed. It is the responsibility of the installer to
ensure that proper antenna and cable combinations are used in order to remain within
FCC Part 15 limits.
The SpeedNet ME Radio is specifically designed to close the longest possible links.
This goal is accomplished in part by delivering the highest permissible RF output power
to the antenna per the FCC Part 15 Rules. In August 1996, the FCC adopted RF exposure
guidelines that established safety levels for various categories of wireless transceivers.
Those limits are consistent with safety standards previously published by the National
Council on Radiation Protection (NCRP) Report 86, §17.4.1, §17.4.1.1, §17.4.2, and §17.4.3
as well as the American National Standards Institute (ANSI) in §4.1 of “IEEE Standard
for Safety Levels with Respect to Human Exposure to Radio Frequency Electromagnetic
Fields, 3 kHz to 30 GHz,” ANSI/IEEE C95.1-1992.
The SpeedNet ME Radio complies with these FCC exposure guidelines when the
following precautions are obeyed:
• One of the exact antennas recommended in this instruction sheet is installed.
• The cable run for the selected antenna exceeds the minimum length quoted in this
instruction sheet.
• All persons maintain a minimum separation of 12 inches (30.48 cm) from the Speed-
Net ME antenna.
Disconnect the ac/dc input power source from the SpeedNet ME Radio whenever
repositioning the antenna. You are responsible for taking the necessary steps to ensure
that these guidelines are communicated to all persons that may come near the SpeedNet
ME Radio antenna.
