SAN-UP MJS 218, Instruction Manual

Page: 11 / 12

Usage of citric acid cleaning mixture or other
cleaning medicament
Troubleshooting
11
Englis
h
1. Turn off and unplug the humidifier.
2. Drain water from the gutter.
3. Put 5 to 10 drop medicament or 1 to 2 gram citric acid grainy
on the transducer., then pour warm water (about 60
ºC
) into the
gutter until the water flows over the heating panel.
4. Brush the surface of transducer and heating panel carefully
2 to 5 minutes later. Repeat the above steps if the scale can’t be
totally cleaned one time.
5. After cleaning up the furring, please wash the sink with fresh
water before you use it.
Standby indicator
not works; no wind;
no mist
Power not connected Connected the power
plug
Water-short indicator
on, no wind, no mist
Short of water Fill with water in
the tank
Mist with abnormal
smell
New appliance Opens the tank and
puts the mouth of the
tank in shade
for 12 hours
Mist generation
abnormal
The transducer
begrimed
Clean the transducer
Dirty water or the
water left too long
Clean the tank and
replace with clean water
Abnormal noise Resonate between the
appliance and the layer
Put the appliance on
a firm layer
Water not used The dirty cover of the
tank or the tank not
put properly
Clean the cover and put
the tank on right place
Too much water in
the gutter
Reduce some water and
re-fix the cover of tank
Dirty water Clean the tank and
replace with clean water
Problem Cause Solution