Samyung SNX-300, Instruction Manual

Page: 64 / 71

60
SNX-300
⑦ Press [ON-LINE] button. “5 (ON ) : Baud” Printout.
⑧ Press [FEED] button. “6 (OFF) : Rate” Printout.
⑨ Press [FEED] button. “7 (OFF) : Select” Printout.
⑩ Press [FEED] button. “8 (OFF) : 4800 bps” Printout.
“Continue ? : Push “On-line SW”
“Write ? : Push “Paper feed SW”. This will be printed out.
Press [FEED] button and the setting will be done. The following will be printed out.
“DIP SW setting complete”
In order to check the preset DIP switch setting, press [ONLINE] button and hold it down for some 2
seconds, simultaneously turning on the power. If the following is printed out, it means it is normally
set at 4800bps.
[ DIP SW setting mode ]
Dip SW-1
1 (OFF) : Input = Serial
2 (ON ) : Printing Speed = High
3 (ON ) : Auto Loading = ON
4 (OFF) : Auto LF = OFF
5 (ON ) : Setting Command = Enable
6 (OFF) : Printing
7 (ON ) : Density
8 (ON ) : = 100%
Dip SW-2
1 (ON ) : Printing Columns = 40
2 (ON ) : User Font Back-up = ON
3 (ON ) : Character Select = Normal
4 (ON ) : Zero = Normal
5 (ON ) : International
6 (ON ) : Character
7 (OFF) : Set
8 (OFF) : = England
Dip SW-3
1 (ON ) : Data Length = 8bits
2 (ON ) : Parity Setting = No
3 (ON ) : Parity Condition = Odd
4 (OFF) : Busy Control = XON / XOFF
5 (ON ) : Baud
6 (OFF) : Rate
7 (OFF) : Select
8 (OFF) : = 4800 bps
“Continue ? : Push “On-line SW”
“Write ? : Push “Paper feed SW”. This will be printed out.
※ If the equipment is set okay, press [FEED] button and the printout is made from DIP SW Setting mode.
If not set okay, press [ON-LINE] button to re-set DIP SW.