======================================================================
======================================================================
SMR-3600
57
Chapter 5. Maintenance
1. General
•
In order to get Radar performed in good order, a periodical maintenance should be done
properly.
•
The unexpected troubles would be less by paying proper attention to timely maintenance.
•
A common maintenance for each component is as follows.
1-1. Cleaning
•
Do cleaning out the dust, salt water adhered to the unit.
•
Cleaning with dry cloth.
1-2. Check out the tightness of screw, bolt
•
Check out the tightness of screw or bolts, which attached on the Unit.
1-3. Check the cabling
•
Do checking and maintaining the cabling between Units periodically (Between
transceiver with Monitor, Between Monitor with Power supply, Between Monitor with
optional equipment).
* Notice : When checked the Units, please be sure to turn off the power to protect from
electric shocking. In case using Rectifire, cut off the power on Monitor because it is still
excited even Radar stopped
.
2. Transceiver
When maintained a transceiver, please be sure to cut off the power of Monitor.
Don’t place watch or electronic card close to the area of modulation, which equips with
Magnetron.
2-1. Radar Dome
•
In case Raydom surface being contaminated by dust, paint, it may arise the attenuation
or reflection of electric wave and cause to lower the performance of Radar, it should be
cleaned out by a soft cloth with alcohol to keep it cleaned at all times.
Summary of Contents for SMR-3600
Page 4: ...1 2 3 2...
Page 5: ......
Page 59: ...SMR 3600 59 Chapter 6 Installation drawing and circuit diagram...
