4
WASHING PROCEDURE
TO WASH
1. Before starting washing, check the following;
- Connect the water supply hose and open the
water tap.
- Connect the power cord to the power supply
outlet.
- Lay the drain hose(A) down toward a sinkhole.
- Place the drain hose(A) in sink or bath about
70~80cm above the ground.
2. Set the WASH SELECTOR
KNOB to the desired
mode.
3. Set the CYCLE SELECTOR KNOB to ‘WASH·RINSE’.
(In case no drain pump) (‘
WASH
’ in case drain pump)
4. Set the WATER SELECTOR
KNOB to WASH .
5. Load laundry in the wash
tub.
6. Fill water in the wash tub
and add the detergent.
7. Set the WASH TIMER 1-15
minutes.
8. After washing,set the
CYCLE SELECTOR KNOB to
‘DRAIN’ for drain.
SPIN DRY
1. Transfer the clothes into the spin basket and
arrange the clothes evenly.
2. Be sure to attach the safety cover and close the
inner lid.
3. Close the spin dryer lid.
4. Set the AIR TURBO SPIN TIMER 1-10 minutes.
5. Incomplete spining. (Severe vibration or
unbalance) See “When you load ...”on page 6.
inner lid
safety cover
(Without pump)
(With pump)
(WITHOUT PUMP)
(WITH PUMP)
70~80cm
Bottom of balancer
Safety cover
WT80J7-02206F_EN.indd 4
2006-06-17 ¿ÀÈÄ 3:59:37
