When you open this
lid while the spin basket is
spinning,the spinning will
be stopped by the break
system.
POWER CORD
SPIN DRYER BASKET
WASH TUB
The plug’s shape
may not be similar to that
shown in this drawing.
SPIN DRYER LID
WASH TUB LID
Be sure to keep the lid
closed during washing
and spinning.
PULSATOR
LINT FILTER
INNER LID
DESCRIPTION AND CLEANING OF PARTS
INSTALLATION
This is used for
gathering the dregs
made during
washing.
CLEANING THE LINT FILTER
•
If the dregs are piled up in the
lint filter after finishing the wash,
push down and pull it
out as shown in the figure.
•
Wash the filter net
in water.
OVERFLOW FILTER
•
Pull the upper side
of the overflow filter with
two fingers inserted into
hole ‘A’ in the
direction of arrow
as shown in the figure.
LOCATION
Leave some space
Space at least 15cm between the
washing machine and the wall.
Place the washing machine on a sturdy
flat surface.
If the washing machine is placed on an
uneven or weak surface, noise or
vibration may occur. (Allowable is 2˚)
Never install the washing machine
near water.
Do not place the washing machine in
steamy room or where the washing
machine is directly exposed to rain.
Moisture may damage electrical
insulation and cause an electrical shock
to occur.
Avoid direct sunlight or heating
devices.
As plastic and electrical components are
affected by direct heat, never place the
washing machine near heaters, boilers,
etc., or under direct sunlight.
A
CLEANING THE WASH TUB
First, fill water in the wash tub to “L”
level(a level that wash tub is almost filled
with water about 4/5) then drain water
from the wash tub simultaneously with
operating wash cycle for 1~2 minutes.
•
Close the wash tub lid.
CLEANING THE WASHING MACHINE
Wipe off stains on the cabinet and
operation pane with a soft cloth.
Neither use benzene, thinner, cleanser,
or wax, nor scrub the washing machine
with a brush. Painted surfaces or
plastic parts will be damaged.
PRECAUTIONS WHEN INSTALLING.
1. Place the washing machine on a sturdy
surface.
2. never support the washing machine with
a brick or a piece of wood for leveling.
During spinning, the may start to vibrate
excessively and even fall down.
CONNECTING THE WATER DRAIN HOSE
1. Fit the water drain to the drain outlet.
2. Push it with force further to the bottom of the
drain outlet.
3. Check the drain hose for not getting apart
from the outlet by drawing it.
2
