Samsung WT12J4200MB/SG, User Manual

Page: 6 / 24

6_ installation
installation
Environment
t How to move the machine.
Wheels are provided for easy translocation of
machine.
- Hold the machine firmly as shown in the figure
below.
Do not move machine when it is loaded.
t Leave some space.
Space at last 15 cm between the washing
machine and the wall.
t Place the washing machine on a sturdy flat
surface.
If the washing machine is placed on an uneven
or weak surface, noise or vibration may be
occurred. (Allowable is 2°)
t Never install the washing machine near water.
Do not place the washing machine in steamy
rooms or where the washing machine is directly
exposed to rain. Moisture may destroy the
electrical insulation and cause an electrical shock
hazard.
t
Avoid direct sunlight or heating devices.
As plastic and electrical components are
affected by direct heat, never place the washing
machine near heaters, boilers,etc. Do not place
under direct sunlight.
Connecting the drain hose
Insert the drain hose(a) and push it tightly to be
connected as arrow direction.
- Push it with force further to the bottom of the
drain outlet
- Check the drain hose for not getting apart from
the outlet by drawing it.
Connecting the inlet hose
(Insert the inlet hose
into washing machine) into faucet)
The new hose-sets supplied with the appliance are
to be used and that old hose-sets should not be
reused.
cleaning the machine
Cleaning the lint filter
If the dregs are filled up in the lint filter after finishing
the wash, push down(1) and pull it out(2) as shown
in figure.
Remove the collected lint and rinse the filter net.
Lint filter
Cleaning the wash tub
Wipe off strains on the cabinet and operation panel
with soft cloth.
Do not use benzene, thinners, cleanser, or wax, nor
scrub the washing machine with a brush. Painted
surfaces or plastic parts will be damaged.
washing procedure
Washing
1. Before starting washing, check the following;
- Connect the water inlet hose and open the
water tap.
- Connect the power cord to the power supply
outlet.
- Lay the drain hose (A) toward a sinkhole.
2. Set the NORMAL / HEAVY SELECTOR KNOB
to the desired mode.
(Insert the inlet hose