INSTALLATION
ENVIRONMENT
HOW TO CLEAN THE FILTER
(In case drain pump)
1. Place a rag under the washer filter
Leave some space
not to wet the floor.
Space at last 15cm between the washer
2. Rotate the filter counterclockwise
and the wall.
and pull out the filter.
3. Remove dirts and rotate
Place the washer on a sturdy flat surface.
the filter clockwise until it
If the washer is placed on an uneven or weak locks in position.
surface, noise or vibration may be occured.
Remark : Should be cleaned
(Allowable is 2°)
Filter at least 1 time a week.
Never install the washer near water.
CONNECTING THE DRAIN HOSE
Do not place the washer in steamy rooms or
Insert the drain hose(a) and push it tighly to be
where the washer is directly exposed to rain.
connected as arrow direction.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
(WITHOUT PUMP)
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
Install the drain hose(A) about 70~80cm above the
ground for pump model.
CHANGING THE POSITION OF THE DRAIN HOSE
Before attempting to change the position of the
drain hose, disconnect the plug from the outlet.
1. Route the drain hose inside the machine.
2. Take out the drain hose from the opposite hole and
insert the drain hose into the hose holder.
CLEANING THE MACHINE
CLEANING THE LINT FILTER
CLEANING THE COVER WINDOW SPIN
If the dregs are filled up in the lint filter after
1. Rotate the cover window spin clockwise and pull out.
finishing the wash, push down(1) and pull it
2. Cleaning the cover window spin.
out(2) as shown in figure.
3. Insert the cover window spin back and rotate it
Remove the collected lint and rinse the filter net.
counterclockwise until locks in positon.
Remark : Should be cleaned the cover window spin
at least 1 time a month.
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners,
cleanser, or wax, nor scrub the washer with a brush.Painted surfaces or plastic parts will be damaged.
3
DC68-01942M_WT10J_VEARAB4 4
3/29/2007 7:23:50 PM