Samsung WS32Z30HEAXBWT, Service Manual, Page: 111 / 216

Troubleshooting
Samsung Electronics 6-21
6-5-2 Troubleshooting Deflection Board
■
Countermeasures by Deflection Types
1. The screen is blank and only the relay repeats close and open when turning the power on.
▶
This happens when the vertical voltage or vertical signal is not supplied, and because the Micom operates for 5 to 10
seconds and then turns the power off by force as it cannot detect the vertical signal..
2. CHECK POINT
- Check that the vertical output voltage is measured in the FBT terminal.
→
VCC (+) : 19.5V ~ 20V
VCC (-) : Higher than 16.5V
▶
If you cannot measure the output voltage, check that the collector voltage of the horizontal TR is 1360V.
If the voltage is measured, the problem is a defect in the FBT unit.
(When you don't have an oscilloscope, and you can hear the high-voltage sound, you can determine that the horizontal TR
is normal.)
- Is the vertical input waveform output from the CXA2165 Chroma IC?
....... Input waveform: Approximately
▶
If the signal is not measured, check the CXA2165 VCC power voltage ====> 9V
3. Check that 15V is the proper output from the SMPS TRANS?
■
Countermeasures against problems
1. The drooping of the top and bottom of the screen is too severe.
▶
This may happen when the N/S correction circuit is out of order.
2. CHECK POINT
→
Measure the terminal V2 of the Vertical DY and check that the N/S correction signal is properly supplied.
→
70Vpp.
▶
If the correction signal is not measured, check that the Lead of L304 (N/S TRANS) is disconnected. If L304 is normal, check
the soldering status of C305 and C439.
The correction signal is approximately 70Vpp.