Samsung WIBT40A User Manual Download Page 7

                                                                                                                                                                 

 

Version 1.0 

Samsung Electronics 

page 7 of 8

 

 

6. Notice 

l. 

Federal Communication Commission Interference Statement 

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 

may cause harmful interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment 

off and on, the user is encouraged to try to correct the interference by one of the following 

measures: 

  Reorient or relocate the receiving antenna.

 

  Increase the separation between the equipment and receiver.

 

  Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.

 

  Consult the dealer or an experienced radio/TV technician for help.

 

 

 

FCC Caution: 

 

Any changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate this equipment. 

 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept 

any interference received, including interference that may cause undesired operation. 

 

 

  

 

  

 

FCC Radiation Exposure Statement:

 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 

environment.   

  

USERS MANUAL OF THE END PRODUCT:

 

The end user has to be informed that the FCC radio-frequency exposure guidelines for an 

uncontrolled environment can be satisfied. The end user has to also be informed that any 
changes or modifications not expressly approved by the manufacturer could void the user's 

authority to operate this equipment. If the size of the end product is smaller than 8x10cm, then 

additional FCC part 15.19 statement is required to be available in the users manual: This device 
complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this 

Summary of Contents for WIBT40A









Reviews: