Samsung WF45R6300AU, User Manual, Page: 55 / 136

English 55
Troubleshooting
Problem Action
The washer stops.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door and press Start/Pause (Hold to Start) to
start the washer. For your safety, the washer will not
tumble or spin unless the door is closed.
• Before the washer starts to fill, it will make a series of
clicking noises to check the door lock and does a quick
drain.
• There may be a pause or soak period in the cycle. Wait
briefly and the washer may start.
• Make sure the mesh filter of the water supply hose at
the faucets is not clogged. Periodically clean the mesh
filter.
• If the washer is not supplied with sufficient power,
the washer temporarily will not drain or spin. As soon
as the washer regains sufficient power, it will operate
normally.
Fills with the wrong
temperature water.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps.
Flush water lines.
• Make sure your water heater is set to supply hot water
with a minimum temperature of 120 °F (49 °C) at the
tap. Also, check the water heater capacity and recovery
rate.
• Disconnect the hoses and clean the mesh filters. The
mesh filters may be clogged.
• While the washer fills, the water temperature may
change as the automatic temperature control feature
checks incoming water temperature. This is normal.
• While the washer fills, you may notice just hot and/or
just cold water going through the dispenser when cold
or warm temperatures are selected. This is a normal
function of the automatic temperature control feature
as the washer determines the water temperature.
Untitled-4 55 Untitled-4 55 2022-12-20 4:13:37 2022-12-20 4:13:37