Removal and Reassembly _ 15
Part
Figure
Description
WATeR LeveL
SeNSoR
(The Hook type)
The Hook type water level sensor
Noise filter
Water valve
Sensor pressure
► Disassembly
1. Separate the Top Assy-Plate.
1. To remove the water lever sensor, push it slowly
in the direction of the arrow shown in the figure on
the left.
Since this disassembly method uses the
elasticity of the water level sensor hook,
imposing too strong a force may damage it.
A
2. While a force is imposed on the water lever sensor
as directed in step 1, pull the hook
A
in the
direction of the arrow until it is removed from the
bracket spring.
B
3. Impose a force slowly in the direction of the arrow
designated in the figure on the left until the hook
B
is removed. Then remove the water level sensor.
► Assembly
1. Connect the pressure hose to the body of the
water level sensor and lock it using the clamp.
When connecting the water level sensor to the
set, make sure to connect it after draining water
by operating the spin cycle.
2. To reattach the water level sensor, insert the hook
back into the square hole until you hear a “click”.
