washing a load of laundry
_23
Spin Only
If you press the
Power
button and then press and hold the
Spin
button for 2 seconds, the spin
time will be displayed on the display panel.
Then, press the
Spin
button repeatedly until the required spin level is selected, and then press
the
Start/Pause
button.
Before pressing the Spin Only button to use the Spin Only function, you can select a cycle
with the Cycle Selector. If you have selected a cycle, you can only select the spin level
corresponding to the selected cycle.
You can add or take out laundry items even after the wash has started, as long as the
“
” light is turned on. Pressing the
Start/Pause
button unlocks the door, unless the
water is too hot or if there is too much water in your washer. If you are able to unlock the door
and wish to continue the wash cycle, close the door, and then press the
Start/Pause
button.
uSING STEAM WASh (Wf363*, Wf365*)
If you select steam, the steam acts at the most effective times for the detected amount of laundry,
maximizing the effect of the steam, increasing the wash temperature, enhancing the Soak effect, and
improving wash performance.
1.
Load the washer.
2.
Press the
Power
button.
3.
Turn the Cycle Selector and select a steam cycle.
4.
Press the
Steam
button.
5.
Add detergent into the dispenser tray for a wash, and add fabric softener up to the marked line.
6.
Press the
Start/Pause
button.
: The washer automatically selects the optimal wash conditions by sensing the weight of the laundry
Steam may not necessarily be visible during the steam cycles and may not be present during an entire
steam wash cycle.
ATC (AuTo TEMPERATuRE CoNTRoL)
ATC is the control function that the washer controls water temperature with temperature sensor (thermistor).
Because there are numerous water temperatures depending on the customer’s environments(cold
areas, warm areas, various water temperature, settings of heater temperature, etcs), ATC function in
our washer maintains the certain level of wash temperature to output the best washing performance at
each cycle.
If you select normal & heavy duty course, those courses are the regulation and UL course. Since new
washer must reduce the amount of energy usage at first priority, customer will notice more cold water
entering the washer. But This is Normal, not a problem.
In those regulation course, Hot temperature is similar to acceptable adult bath-water temperature and
warm temperature is similar to comfortable swimming-pool water temperature.
If customer want to wash clothes in specific water temperature, customer should choose a different
course at each temperature(Hot/Warm/Eco Warm)
02 w
ashing a load of laundr
y
WF361_363_365-02832J-07_EN.indd 23
2014-2-22 15:58:17
Summary of Contents for WF363 Series
