Samsung WF306LAW/XAA, Service Manual

Page: 27 / 89

4-6
4-2-6. Cycle Count Check Mode
Definition of Cycle Count Check Mode:
- Cycle Count Check Mode is to tally up the number of washings.
How to Enter:
- To enter the Cycle Count Check Mode, press the Signal Key during Special Test Mode.
(same for all Frontier models.)
Cycle Count Check Mode:
1. Activate the Special Test Mode in advance.
2. When the Signal key is pressed, the total number of washings will light up and a signal LED will glow (Louder, Softer, Off LED).
3. The maximum number of cycles will be 2999.
The counter will roll over to 0 and start counting again after 2999.
4. The counting will be carried out at the end of the normal cycle.
(During Continuous Run Mode, it does not Do not count any cycle in Continuous Run Mode)
5. To exit the Cycle Count Check Mode, press the “Signal” key again.
Then, it returns to the Special Test Mode with motor RPM illuminating.
4-2-7. S/W Version Check Mode
Definition of S/W Version Check Mode:
- S/W Version Check Mode is to bring up S/W Version information.
How to Enter:
- To enter the S/W Version Check Mode, press the Soil Level Key during Special Test Mode.
(same for all Frontier models.)
S/W Version Check Mode:
1. Activate the Special Test Mode in advance.
2. Press the Soil Level Key to bring up its software Version
Ex) Generate U005 at U005
3. To exit the S/W Version Check Mode, press the Soil Level S/W once again.
Then, it returns to the Special Test Mode with motor RPM illuminating.