2.
Open the ceiling clip so that it is wider than the width of the T-bar.
3.
Move the ceiling clip so that it is appropriate for the T-bar width.
4.
Fix the ceiling clip in place by tightening
the 4 designated screws.
Screws for fixing
the ceiling clip
5.
Fix the T-bar in place by fastening the
screws (total of 2) that are on the ceiling
clip.
Screws for
fixing T-bar
If the T-bar size of the ceiling is 15 mm,
24 mm or 38 mm, the position to fix
the ceiling clip can be checked from
the bottom surface of the mounting
bracket. If the T-bar size is unknown,
push the ceiling clip to check the fixing
positions.
6.
Pull out a LAN cable through a hole on the
ceiling and connect it to an Ethernet port
(PoE) on the back side of the WEA512i.
Exterior of the ceiling
If PoE is not supported, connect the power adapter to the DC input on the
back side of the WEA512i.
7.
Align the WEA512i with the
3 holes on the mounting bracket
and then turn clockwise to fix
it in place. Clean up the ceiling
and other cables.
Interior of the ceiling
Installation on Walls
1.
Remove the holding tape that was
attached to fix the ceiling clip.
Holding tape
2.
Remove the ceiling clip from the mounting bracket.
3.
Place the mounting bracket on the wall.
Mark and drill 4 screws in appropriate spots.
4.
Use a hammer to insert
4 plastic anchors into the
drilled holes on the wall.
Align the inserted plastic
anchors and the screw
holes of the bracket.
Fix the bracket to the wall
by fastening four M4 × L28
screws.
5.
Insert a LAN cable into the Ethernet port
(PoE) on the back side of the WEA512i.
The wall
If PoE is not supported, connect
the power adapter to the
DC input on the back of the
WEA512i.
Installing Anti-Theft Lock Cable
When installing the WEA512i in a public place, it is recommended to use
anti- theft lock cables to prevent any loss. (An anti-theft lock cable can be
purchased separately and a variety of products can be found in the market.)
1.
Connect the anti-theft lock cable to the WEA512i.
or
2.
Turn the lock cable key to lock the cable.
3.
Remove the key from the lock cable and keep it in a separate location.
Using the anti-theft Torx screws
The WEA512i can be prevented from being stolen when tightening the Torx
screws as shown below. (Torx screws can be easily tightening when they
are fixed to the mounting bracket before assembling the AP product.)
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
The 5150-5250 MHz band is restricted to indoor use only.
RF Radiation Exposure Statement:
This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 cm between the
radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Should the AP be installed in a ceiling with ventilation, the AP Ethernet port
must be horizontally placed.
This product is RoHS compliant.
Frequency Range
Output Power (Max.)
2400~2483.5 MHz (WLAN 2.4G)
5150~5725 MHz (WLAN 5G)
5725~5875 MHz (non-Specific SRD)
19.49 dBm
28.70 dBm
13.46 dBm
AT
BE
CY
DK
EE
FI
DE
EL
IE
LU
MT
NL
SI
ES
SE
UK
NO
CH
http://www.samsungenterprise.com
Part No.: EC68-00205A (Ver.1.0)
