SAMSUNG
Washing Machine Owner’s Instructions
A-4
Connecting the water supply hose (Option)
1.
Remove the adaptor from the
water supply hose.
c
4.
Connect the water supply hose to
the adaptor. Pull down part (c) of
the water supply hose.
When you release part (c) the
hose automatically connects to
the adaptor making a ‘click’ sound.
2.
First, using a ‘+’ type screw driver,
loosen the four screws on the
adaptor. Next, take the adaptor
and turn part(b) following the
arrow until there is a 5mm gap.
5.
Connect the other end of the
water supply hose to the inlet
water valve at the rear of the
washer. Screw the hose clockwise
all the way in.
3.
Connect adaptor to the water tap
by tightening the screws firmly.
Then, turn part (b) following the
arrow and put(a) and (b) together.
a
b
NOTICE
After completing connection, if water leaks from the hose, then repeat the same steps. Use
the most conventional type of faucet for water supply. In case the faucet is square or too big,
remove the spacing ring before inserting the faucet into the adaptor.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a wash basin.
The drain hose must be placed at a height of between
60 and 90 cm. To keep the drain hose spout bent, use
the supplied plastic hose guide. Secure the guide to
the wall with a hook or to the faucet with a piece of
string to prevent the drain hose from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above
the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60 cm and no
longer than 90 cm.
Environment
Please dispose of the packaging materials for this product in an “environmentally friendly” manner.
For further detail, please contact your local area authority.
Installing the Washing Machine
WD7704C8S-02410P_EN.indd 4
2007-10-22 ¿ÀÀü 11:58:53
