16_
installing your washer
2.
Check the inlet hoses to ensure a washer is inside the
coupling of each fill hose.
Thread the inlet hoses onto the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber washer
per hose and attach each fill hose to the water valve. Make
sure the hose with Hot printed on it is attached to the HOT
faucet. Tighten by hand until snug, then add two-thirds of a
turn with pliers.
For correct water use, connect both HOT and COLD water
valves. If either or both are not connected, an “nF” (no fill)
error can occur.
3.
Turn on the “HOT” and “COLD” water supplies and check all
the water valve and the faucet connections for leaks.
4.
Plug the power cord into a 3-Prong, well grounded
220~240V/50Hz approved electrical outlet protected by a
comparable circuit breaker.
Your washer is grounded through the third prong of the
power cord when plugged into a three-prong grounded
receptacle.
5.
Slide your washer into position.
6.
Level your washer by turning the leveling legs in or out as
necessary by hand.
Your Washer must be level back to front and side to side. Use a carpenter’s level on all four
corners of your Washer to level it. It’s a good idea after the first dozen washes to recheck
your washer to ensure it is still level.
ENVIRONMENT
Please dispose of the packaging materials for this product in an “environmentally friendly” manner.
For further detail, please contact your local area authority.
installing your washer
Cold
Hot
Cold printed
Hot printed
Rubber Washer
WA5471ABP-03050B_EN.indd Sec3:16
WA5471ABP-03050B_EN.indd Sec3:16
2012-01-12 5:24:15
2012-01-12 5:24:15
