Samsung WA45n3050A Series, User Manual

Page: 27 / 204

English 27
Ins
tallation
STEP 5 Powering your washer
Plug the power cord into a 3-prong,
well grounded 120 volt 60 Hz approved
electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third
prong of the power cord when plugged into
a three-prong grounded electrical outlet.
Test run
Make sure that you install your washer
correctly by running the
RINSE + SPIN after
the installation is complete.
STEP 6 Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1.
Load about 6 pounds of laundry into the tub.
2.
Press POWER to turn on your washer.
3.
Select RINSE + SPIN by turning the Cycle Selector .
4.
Press START/PAUSE to start the test cycle.
5.
The washer should not rock or vibrate excessively when water is supplied or when
washing or spinning, and should drain well during the spin cycle.
NOTE
If water leaks while water is being supplied or drained, check the water connections. Refer to
the “
STEP 2 Connecting the water supply hose ” section on page 21 for instructions.
NOTE
If the washer rocks and vibrates excessively, level your washer again. Refer to the “ STEP
4 Leveling your washer ” section on page 25 for instructions.
WA3100M_DC68-03850A-05_EN.indd 27 2019-02-14 6:21:50