11
2-5 TEST PROGRAM MODE
2-5-1 TEST MODE FUNCTION (Drive and other test)
1) How to enter: (Water level + Power s/w)
2) MODEL change: you may change mode by pressing COURSE key in test mode.
3) Mode discription
MODE NO. DISPLAY
TEST CONTENT
REMARKS
1
"01"
AGING TEST FOR DRIVING Drive and Display turn ON/OFF
as follows. SPIN LAMP (DRAIN/MOTOR) Cold water. Hot
water SPIN LAMP (RINSE) "r" 7-SEG (MOTOR RIGHT) "L"
Open and close
door, and you
may run spin
after UNB.
2
"02"
SPIN AGING MODE
After detecting reset in 50 sec. it proceeds starting
intermittent spin in 3rd times and then continues spin course
in the order of 5 min. ON and 3 min. OFF.
If the initial water level is under reset it starts intermittent
spin after 20 sec.
- Door error or unbalance error will be detected and
displayed as follows.
Door error : "dE" UNBALANCE ERROR : "UE"
3
"03"
It is selected under the condition of high water level set (Hot
water/Cold water) and motor starts rotating repeatedly after
supplying high water level.
4
"04"
Water level sensor is marked by HEX-DECIMAL VALUE in
water level frequency.
5
"05"
Weight sensor is marked by HEX-DECIMAL VALUE as med.
low, extra low when pressing the water level key.
6
"06"
Weight sensing test/value indicate mode Start key-in performs
weight sensing and total pulse number displays after
selecting water level. It is marked on the 7-SEGMENT under
100, SPIN LAMP turns ON over 100 and RINSE AND SPIN
LAMP turn ON over 200.
7
"07"
TEST MODE OF WATER SUPPLY VALUE cold water for
RINSE VALUE turns ON/OFF by 2 sec. REPEATED MODE
8
"08"
"OE"
Med. low, extra low A/D PORT OPEN/SHORT PIN NO DISPLAY
OVER FLOW ERROR FUNCTION
It performs the release function during in operation which
drains overflow water level to selected water level by 2 times
and performs overflow error function in 3rd times when over
error happens keeping motor going on until power OFF
