8. SILVER RINSE BUTTON
• During the last rinse after the wash, silver water is supplied together and
the soak washing will be followed. This prevents propagation of bacteria
through a sanitizing rinse and antibiotic coating on the washed cloth.
• The Silver Rinse button can be selected at any course.
9. SILVER WASH COURSE
• It is a sanitizing, sterilizing course that silver water is fed at the same time
during the water supply. Its initial stage of washing is performed in high
concentration (water is supplied to the 80% of selected water level), and
then silver sterilizing and soak washing will be followed after water supply
to the 100% of selected level.
• If hot water is only selected, the Silver Wash button can not be selected.
10. COURSE SELECT BUTTON
• Select the course depends on each laundry and how dirty the garments
are;
FUZZY
➔
SILVER WASH
➔
BLANKET
➔
SPEEDY
➔
WOOL
➔
CLEAN TUB
• Refer to the User's Manual for explanation of each course.
11. DELAY START BUTTON
• Use when you want to set up the finishing time for washing.
• If you want to cancel the reservation, power off.
12. START/HOLD BUTTON
• Use to pause and restart the operation.
• To change the washing procedure during operation, press this button to
stop, and once again to restart after changing the procedure.
13. POWER BUTTON
(Use for turning on or off the power.)
• The power goes off automatically as the wash cycle finishes.
• If the power is on for 10 minutes without selecting any other function key,
the power goes off automatically.
About Silver Rinse, Silver Wash System.
•If you select only hot water with [Water Temp] button, the [Silver Wash]
button will not be selected. (Silver Rinse button can be selected)
This is a equipment to which silver water is supplied together
with feed water, and it will not function for the sake of protection of
silver Wash system if only hot water is selected.
It is available only if Cold water or Cold+Hot water were selected.
REMARK
Silver Rinse : If it is used with fiber softener, its effect can be
decreased.
HOW TO WASH AUTOMATICALLY
DEPENDS ON THE LAUNDRY?
BEFORE STARTING WASHING, CHECK THE FOLLOWING
Turn on the faucet to open.
• Check if the water supply hoses are correctly
connected to cold and hot water.
Plug the power cord in.
Make sure to lay down the drain hose.
(In case no drain pump)
SPECIAL NOTES!
Automatic Sensing Function
• At every course (except, wool course) the amount of laundry is automatically
sensed and then appropriate water level, washing time, rinsing cycle, and
spinning time are automatically selected for automatic washing.
• After the power is on, a course is selected and Start/Hold button is pressed.
Then, the washing board starts spinning without water. This action senses
how much laundry is in the washing basket, not a machine problem. After
this sensing process, water supplies automatically.
Adding Detergent and Softener
• It senses the amount of laundry and indicates the water level and amount of
detergent. Then, it starts water supply right away.
• During the water supply, it is possible to open the detergent box and add
detergent. However, it is better to press Start/Hold button to stop water
supply and add detergent. Close the lid and press Start/Hold button again.
This way is much more convenient.
• If the softener is inserted in the softener dispenser, it automatically adds in
at the last rinsing cycle.
- 7 -
