18_installation & maintenance
installation & maintenance_19
installation & maintenance
ASSemBLING THe RAT PROTeCTION PANeL (OPTION)
Tilt the washer a little and lift up the panel until it clicks, finally fix the panel with screw
to the base as shown in the figure.
1.
Insert the rat protection panel to the
assembling hole on back side to the end.
2.
If you have difficulty inserting the panel lift
up the washer a little and insert it.
HOW TO CONNeCT THe DRAIN HOSe (OPTION)
IN CASe Of PUmP-DRAINeD WASHeR
cap-hose
Take out the cap-hose and connect the
outlet-hose.
Be sure to join tightly the drain hose into the
drainoutlet on the back of the machine.
90~100cm
Be sure to join tightly the drain hose into
the drain-outlet on the side of the machine.
Install the drain hose in the position of about
90~100cm above the ground.
Rear-side
WA10G9TEC-02961C-04_EN.indd 18
2012-11-13 �� 4:58:24