Install the drain hose in the
position of about 90~100cm
above the ground.
8
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
(a)
(b)
70~80cm
Be sure to join tightly the drain
hose into the drain-outlet
on the side of the machine.
Be sure to join tightly the drain hose into
the drain-outlet on the back of the
machine.
Take out the cap-hose and
connect the outlet-hose.
IN CASE OF PUMP-DRAINED WASHER
cap-hose
outlet-hose
ASSEMBLING THE RAT PROTECTION PANEL
1.Insert the rat
protection panel
to the assembling
hole on back side
to the end.
2.If you have difficulty
inserting the panel
lift up the washer a
little and insert it
HOW TO ADD THE FABRIC SOFTENER
90~100cm
1.Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim over the box.
HOW TO PUT THE DETERGENT IN
Detergent Device
Put the detergent
in proportion to
water level
Softener Device
Softener
baseline
CAUTION : If softener is stored over the above base line, it may flow down at any time.
•
When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
•
Do not use detergent, bleach or starch into
the Softener Inlet.
•
Using too much softener may produce
unsatisfactory results.
•
Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
•
Do not leave the softener
into the Softener
Dispenser for a long time.
Because softner
became stiff.
BP8-01518W-GB 2/13/03 10:47 AM Page 9
