1-7
EN
Cleaner will not run.
1. Not firmly plugged in.
1. Plug in firmly.
2. No voltage in wall plug.
2. Check fuse or breaker.
Cleaner does not
1. Dust bag is full.
1. Change dust bag.
Pick Up properly
2. Hose clogged with
2. Remove the substance.
a large object.
IF YOU HAVE A PROBLEM
OUTLET FILTER
1) Separate the exhaust filter.
2) Reassemble it after cleaning or replacing
the filter in the reverse order.
NOTE:
The filters must be completely dried before being replaced in the dust compartment.
This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory.
If a minor problem occurs, it can usually be solved quite easily when the cause is found. Therefore, this
check list is provided for your convenience.
CYCLONIC FILTER
(ONLY CYCLONIC FILTER TYPES)
You can use a dust bag in your cleaner for a long time thanks to the Cyclonic Filter system and it main-
tain the maximum cleaning efficiency.
The larger particle of dust filtered from Cyclonic Filter remain in Dust Barrel when suctioned air and dust
revolves in the Cyclonic Filter. So the dust bag contains only smaller ones.
When the Dust Barrel is filled with dust up to the indicating line, it needs disposing and cleaning.
Dust Barrel can be cleaned in water.
1.Turn the Dust Barrel to the left and pull it.
2.Disconnect the Cyclonic Filter from extension wand and handle.
3.Remove thread and hair tangled around the net.
4.After cleaning the Dust Barrel and Cyclonic Filter,connect the Cyclonic Filter with extension
wand and handle(washed part should be dried in the shade throughly before assembling).
5.Push and turn the Dust Barrel to the right.
Adjust indicating marks each other carved on Dust Barrel and Cyclonic Filter.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
CREVICE
TOOL
CYCLONIC FILTER
DUST BARREL
6800-IB(EN)1 11/1/01 9:04 AM Page 8
