Samsung UP1500 800-A1, User Manual

Page: 50 / 76

UP1500 User’s Manual Chapter 4 Software Support
UP1500 800-A1 4-18
Example 4-12 Using com*_baud
>>> set com1_baud 19200
Embedded Remote Console only supports 9600 baud. Continue?
(Y/[N]) n
bad value - com1_baud not modified
>>>
console The operator console terminal can be either a graphics monitor or a serial
terminal. The
console
environment variable specifies which is used. The syntax
is:
set console output_device
The options for
output_device
are:
Whenever you change the value of
console
, you must reset the system by
pressing the Reset button or issuing the
initialize
command.
ew*0_mode Sets an Ethernet controller to run an Ethernet network. The default value is
auto-sense
. For the fast setting, the device defaults to fast.
The syntax is:
set ew*0_mode value
The options for
value
are shown in Table 4-11.
graphics
(default)
The operator console terminal is a graphics monitor or a device
connected to the VGA or TGA module.
serial
The operator console terminal is the device connected to the
COM2 port.
Table 4-11 ew*0_mode Options
Option Description
aui
Device type is AUI.
auto-sense
Device type is sensed by the SRM Console.
twisted-pair
Device type is 10BaseT (twisted pair).
fast duplex,
twisted-pair
Device type is duplex 10BaseT
fast
Device type is fast 100Base TX
fastFD
Device type is fast full duplex 100Base TX
BNC
Device type is BNC
auto-negotiate
DE500-BA provides auto-sensing capabilities