English - 23
Initial setup
The initial setup dialogue box appears when the TV is first activated. Follow the on-screen
instructions to finish the initial setup process such as selecting the menu language, scanning
channels, connecting to the network, and more. During each step, either make a choice
or skip the step. You can manually perform this process at a later time in the
System
>
Setup
menu.
-
If you connect any external device to
HDMI1
before starting initial setup, the source of your
live TV signal is set to
STB
. After finishing with this process, you will not be able to scan all
channels and stores them in the TV’s memory.
-
If you want to connect aerial cable to your TV, select
Aerial
. In this case, you will be able to
scan all channels and stores them in the TV’s memory.
Samsung's ‘On TV’ Recommendations Service
The
On TV
service recommends TV programmes based on their popularity or your personal
preferences. To enjoy the On TV service, please follow the steps below. (You must have an
Internet connection.)
1. Configure your TV
: Select the
TV
source to be used for
On TV
.
Aerial
: Freeview, Freesat, DVB-T/C/S
Set-top box
: External Cable Box, External Satellite Box
2. Auto tuning channels
: This step only occurs if ‘
Aerial
’ was selected in step 1.
3. Select a Service Provider
: To select your preferred programme provider for On TV, enter
your postcode and select your Freeview, Freesat or external satellite television provider
from the displayed list.
4. Set-top Box Control Test
: This test is to check if your TV remote is able to control your Set-
top Box. This step only occurs if ‘
Set-top box
’ was selected in step 1.
Password Change
System
>
Change PIN
To alter the default setting of the TV, change the password.
Changing the TV’s password.
1.
Run
Change PIN
and then enter the current password in the password field. The default
password is “0-0-0-0”.
2.
Enter a new password and then enter it again to confirm it. The password change is
complete.
-
If you forgot your PIN code, press the buttons in the following sequence to reset the PIN to
“0-0-0-0”:
For the Standard Remote Control
: In Standby mode:
MUTE
→
8
→
2
→
4
→
POWER
(On)
For the Samsung Smart Control
: When the TV turns on:
MUTE
→
Volume up
→
RETURN
→
Volume down
→
RETURN
→
Volume up
→
RETURN
[78HU8500-XU]BN68-06499H-00ENG.indb 23
2014-06-09 10:23:09
