Samsung TXJ2060, Service Manual

Page: 16 / 68

Alignment and Adjustments
3-6 Samsung Electronics
3-3-2 Automatic Degaussing
A degaussing coil is mounted around the
picture tube, so external degaussing after
moving the TV should be unnecessary.
However, the receiver must be properly
degaussed upon installation.
The degaussing coil operates for about 1
second after the power is switched ON. If the
set has been moved or turned in a different
direction, disconnect its AC power for at least
10 Minutes.
If the chassis or parts of the cabinet become
magnetized, poor color purity will result. If
this happens, use an external degaussing coil.
Slowly move the degaussing coil around the
faceplate of the picture tube and the sides and
front of the receiver. Slowly withdraw the coil
to a distance of about 6 feet before removing
power.
3-3-3 High Voltage Check
CAUTION : There is no high voltage
adjustment on this chassis. The B+ power
supply must be set to 135V or +125V
(for 20Ó screen). Conditions : Full color bar
input and normal picture level.
1. Connect a digital voltmeter to the second
anode of the picture tube.
2. Turn on the TV. Set the Brightness and
Contrast controls to minimum (zero beam
current).
3. The high voltage must not exceed 29.5KV.
4. Adjust the Brightness and Contrast controls to
both extremes. Ensure that the high voltage
does not exceed 29.5KV under any conditions.
3-3-4 FOCUS Adjustment
1. Input a black and white signal.
2. Adjust the tuning control for the clearest
picture.
3. Adjust the FOCUS control for well defined
scanning lines in the center area of the screen.
3-3-5 B+ Line Check
There are 3 power modes :
1. ÒAÓ : When AC power supply is connected ;
Ò Stand-ByÓ mode.
2. ÒBÓ : When Ò Set Power-ONÓ button is
pressed.
3. ÒCÓ : Driven by FBT.
Each voltage is marked on its lead-in wire.
( )
3-3-6 F/S (Fail Safe) Circuit Check
1. The failsafe circuit check is the final step after
servicing.
2. Turn the power switch on and adjust the
screen for ÒNormalÓ.
3. Temporarily short Pin R and Pin X on the
chassis (RX05, RX04). Sound and picture will
disappear.
4. The TV should remain in this state. This
shows that the failsafe circuit is working
properly.
5. To restore picture and sound, temporarily turn
off the AC power supply. After about 30
seconds, switch power ON.
21” ± 1
27.5KV
25”
29.5KV
29”
29.5KV
29”± 1
29.5KV
SIZE
MAX
H-VOLTAGE