6-9
(6) In case of no spinning
Is it draining?
No
Pulsator blades are rotating?
No Spinning
Check motor lead wire.
V-belt tension is too strong
or too weak?
Is the lid open?
Safety S/W terminal is lifted
up when lid closed?
Terminals of safety
S/W COM and DOOR
continuous?
Unbalance status?
Any foreign
materials between the spin
tub and TUB?
Spin tub is
rotating correctly?
No
Motor is defective
Replace it.
This is normal as designed to
drain before spinning.
Yes
Drain motor makes
operating sounds?
Yes
Drain Motor operable as a
single unit?
Improper adjustment of
Clutch part. Repair it.
Replace defective drain motor
lead wires.
Improper adjustment of
Clutch part. Repair it.
No
Yes
Drain motor shows
continuity?
Replace Drain Motor.
No
Yes
Yes
Yes
No
No
No
No
No
No
No
No
Remove foreign
materials.
Spin tub is
rotating correctly?
OK.
Yes
Yes
Replace defective
PCB ASS`Y.
No
Unbalance 1st, 2nd
times automatically
dose water
Supply → Wash.
Replace safety S/W.
Check and adjust
safety switch.
Educate customer to
close the lid.
Adjust tension of the
V-belt.
Yes
Yes
Yes
Yes
Yes
Yes
Summary of Contents for SW85ASP
