Samsung SW80W1, Service Manual

Page: 9 / 35

4-4 Description of Technical Points
4-4-1 Weight Recognizing Function
1. Weight recognizing function works first washing
operating before water is supplied, not in WOOL
course and Manual function operation (Wash,
Rinse, Spin, ..... )
2. Weight recognizing function is cancelled when
water level key is pressed prior to the completion of
weight recognizing function.
3. If the current water level is above lowest at the
beginning of weight sensing, it is automatically
decided as a high level.
4. If you change courses after sensing weight, the high
water level is automatically selected irrespective of
the water level decided by the sensing of weight.
4-4-2 Water Supplying Function
1. Relations between water level, frequency & water
supply capacity.
2. Relations between Hot/Cold selection & cycle.
3. If the water level does not reach to the water level
selected for 60minutes after starting water
supplying, the water supplying Error is displaying
on the display.
4. Supplementary water supplying is performed
every Washing or Rinsing operating. The steps are
as follows.
●
supply water to the water level selected,
●
perform the washing or Rinsing operation for 1.5
minutes.
●
sense the present water level after stopping
Motor.
●
compare the present water level to the water
level selected.
●
if present water level < the water level selected,
supply water to the water level selected.
if present water level
≥
the water level selected,
continue the washing or Rinsing operation.
●
But total time of supplementary water
supplying is not over 30 seconds.
4-4-3 Soak Function
1. This course works only when Soak washing is
selected by course select key.
2. It works repeatedly during set time by every 5
minutes(operation for 1 minute and pause for 4
minutes) for 30 minutes after water is filled to
selected water level.
3. If water level is set higher during the Soak
procedure, Soak procedure stops and water is
refilled, and then, keeps on going the Soak
procedure.
4. Washing cycle of 20 minutes begins after Soak
function completion.
Rinsing times can be adjusted according to Soak
washing procedure.
4-4-4 Fuzzy Function
This function recognizes the quantity of laundry
load and selects the water level by itself and keep
on going washing operation automatically.
4-4 WASHING MACHINE
4. Operating Instructions
unit :
l
fre :
KHz
RESET
MIN
LOW
MEDIUM
HIGH
0 24.8
32 l 23.8
38
l
23.4
46
l
23.0
57
l
22.6
amount of water
fre
supplied
Hot/Cold
Wash Rinse
Supplementary
Pre
Remarks
selection
Water supply
spinning
Cold Cold Cold Cold Cold
Hot / Cold Hot / Cold Hot / Cold Hot / Cold Hot / Cold
Hot Hot Hot / Cold Hot / Cold Hot / Cold