6
INSTALLTION
ENVIRONMENT
Leave some space
Maintain at least 10cm between the washer and
the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration occurs.
(Allowable is 1
˚
)
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
causing an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected
by direct heat, never place the washer near
furnaces, boilers, etc. Do not place under direct
sunlight.
ASSEMBLING THE SOUND ABSORBING
PANEL Option
Tilt the washer a little and lift up the panel until clicks,
finaly fix the panel with screw to the base as shown
in the figure.
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain
hose(b) to drain direction.
LEVELLING
SEE IF THE MACHINE PLACED LEVEL BY
CHECKING THE POSITION OF THE WASHING TUB.
•
Open the lid of the machine, pour water into the
tub up to the level just below the pulsator, and
adjust the legs so that the pulsator is positioned
at the center of the water as shown in the figure.
•
Place the machine more than 10cm away from
the wall.
•
Adjust the legs on feet for leveling.
1. Push the upper part of
the filter and pull in.
2. Open the cover as
shown in the figure.
Rear-side
(a)
(b)
WATER
LOOSEN
LOCK
CLEANING THE MAGIC FILTER
3. Clean the filter.
4. Close the cover and insert the
lower part of the filter in the
basket first and then push the
filter with "click" sound.
How to sue the FABRIC SOFTENER
1. Case 1
Fill the water and then, put the “RINSE” into the basket
for rinse cycle.
2. Case 2
In case of use Softener box, operate like following.
1) Put the Softener into the Softener box.
2) Operate following procedure.
Wash
→
Drain
→
Spin
→
Rinse1
→
Drain
→
Spin
→
Rinse2
→
Drain
→
Spin
3) Softener will be flowed into the basket at “Rinse2” cycle.
•
When a proper amount (one time does) of fabric
softener is stored in the softener inlet, it is
automatically put in at the last rinsig cylce.
•
Do not use detergent, bleach or starch into the
Softener lnlet.
•
Using too much softener may produce unsatis-
factory results.
•
Do not open the lid during the Spin Dry cycle.
If added too early,
its effectiveness will decrease.
•
Do not leave the softener into
the Softener Dispenser for a
long time.
Because softner became stiff.
