4
INSTALLATION & MAINTENANCE
ENVIRONMENT
Leave some space.
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise and vibration can occur
(allowable slope is 1 degree)
Never install the washer in a very steamy
environment or where it might be open to the rain.
Excessive moisture may cause an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected
by direct heat,never place the washer near furnaces,
boilers,etc.Do not place under direct sunlight.
IN CASE OF PUMP-DRAINED WASHER
Take out the
cap-hose and
connect the
outlet-hose
Be sure to join tightly
the drain hose into the
drain-outlet on the left
side of the machine.
Install the drain
hose in the position
of about 70~80cm
above the ground.
HOW TO CONNECT WATER SUPPLY HOSE
Check the type of tap fitting which is in your laundry and then see appropriate instruction below:
A tap of ordinary type is desirable
ORDINARY TAP SQUARE TAP ROTATING TAP
In case of square tap
Take out the internal part of the connector
and join it in the following way.
1. Remove the adaptor from the
water supply hose.
4. Connect the water supply hose to
the adaptor. Pull down the part
(c) of the water supply hose .
When you release part (c) the
hose is automatically connects to
the adaptor making a 'click' sound.
2. First,using a "+" type screw
driver, loosen the four screws on
the adaptor.
Next,take the adaptor and
turn part(b) following the
arrow for gap about 5mm
between them.
5. Connect the other end of the water
supply hose to the inlet water valve
at the top of the washer.
Screw the hose clockwise all the
way in.
3. Connect adaptor to the water
tap by tightening the screws
firmly.
Then,turn part (b) following
the arrow and put (a) and
(b)together.
6. If the water tap is a screw type,
assemble a water supply hose that
fits to the tap as shown.
Note
: The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not
be used.
Internal part
SW68ASP-02290A-EN.indd 4
2006-08-21 ¿ÀÈÄ 8:33:11
