8_
Setting up your washer
Setting up your washer
_9
HOW TO WASH AUTOMATICALLY DEPENDS ON THE LAUNDRY
Before starting washing, check the following;
•
Connect the water supply hose to the water tap. Leave a tap open. Plug the power cord in. Make sure
to lay down the drain hose.
Washing for the first time
Before washing clothes for the first time, you must run a complete cycle without clothes.
To do this:
1.
Press the
Power
button.
2.
Open the detergent drawer and insert a little detergent.
3.
Turn on the water supply to the washing machine.
4.
Press the
Start/Hold
button.
This will remove any water from the manufacturer’s test run remaining in the machine.
Special notes!
Automatic Sensing Function
•
At every course (except Clean tub, delicate course) the amount of laundry is automatically
sensed and then appropriate water level, washing time, rinsing cycle, and spinning time are
automatically selected for automatic washing.
•
After the power is on, a course is selected and
Start/Hold
button is pressed. Then, the
washing board starts spinning without water. This action senses how much laundry is in
the washing basket, not a machine problem. After this sensing process, water supplies
automatically.
Adding Detergent and Softener
•
It senses the amount of laundry and indicates the water level and amount of detergent. Then,
it starts water supply right away.
•
During the water supply, it is possible to open the detergent box and add detergent.
However, it is better to press
Start/Hold
button to stop water supply and add detergent.
Close the lid and press
Start/Hold
button again. This way is much more convenient.
•
If the softener is inserted in the softener dispenser, it automatically adds in at the last rinsing
cycle.
Put the laundry into the washer and add detergent, too.
•
Be careful not to overload. Use right detergent for the fabrics you are washing.
•
If the lid is open while running, the washing machine is stopped automatically for safety.
(Except, water supply continues while the lid is open.)
•
When hot water is selected, both cold and hot water are supplied for the first 20
seconds in order to protect the clothes.
•
Possible to control the washing time, rinsing cycle, and spinning time at every course
during the washing.
01
Setting up your washer
SW50USPIW-02447K_EN(ÀÓ½Ã).indd 9
2009-05-29 ¿ÀÈÄ 3:26:59
