Syntax: XX [path] filename. Where [path] filename represents where the source file can be
found on the SVMi-20E.
Terminal operation: Open an Xmodem file receive window. (Transfer/Receive Xmodem).
RX - Move a file from the PC attached to the SVMi-20E Serial Port to the SVMi-20E.
Syntax: RX [path] filename. Where [path] filename represents where the destination file will be
sent on the SVMi-20E.
Terminal operation: Open an Xmodem file send window (Transfer/Send /Xmodem/filename).
9.2 LAN Port
The LAN port on the SVMi-20E is used for Programming, Back Up and Restore, and UPLOADING (send-
ing) and DOWNLOADING (receiving) files to and from the SVMi-20E. This connector is designed to con-
nect to the customer's internal Local Area Network (LAN) using a straight through RJ45 10/100baseT
cat5 cable or directly to a PC via a RJ45 10/100baseT cat5 Crossover Cable.
The LAN port MUST use a static IP address. The default address is: 10.10.108.6
For more information on this see additional Documentation on, 'Back Up and Restore' and 'FTP'.
9.2.1 LOCAL PROGRAMMING VIA LAN
Connect the LAN port of the SVMi-20E unit directly to a PC via a RJ45 10/100baseT cat5
Crossover Cable.
Setting Up the Network Device on your PC or Laptop
You need to consult your Operating Systems user's manual for how to set up a network con-
nection. Below is a suggestion on how to set up a connection using Windows 2000. It is still
recommended that you refer to your own user manual for details.
1.
From your desktop right click on "My Network Places" then select Properties
2.
Right Click LAN connection device you will use to connected to the SVMi-20E then select
Properties
3.
Select Internet Protocol (TCP/IP) then select Properties
4.
Select radio button for "Use the following Address"
5.
Set IP Address: to 10.10.108.5
6.
Set Subnet Mask: to 255.255.255.0
7.
Set Default Gateway: to 10.10.108.1
8.
Click on OK
9.
Click on OK again
10. Close Network Places Window
SVMi-20E Installation / May 2009
11
Home Page
