9
NOTE : When closing the cover, press the center of printer cover firmlay
to prevent Paper miss-loading.
5. Be sure to note the correct direction that the paper comes off the roll.
6. Close the cover.
7. Tear off the paper as shown.
NOTE : Both Power and Error LED is blank when the mecha cover is
open.
1-8. Using the Printer
Control Panel
Button
The button can be disabled by the ESC c 5 command.
Press the FEED button once to advance paper one line. You can also hold down the
FEED button to feed paper continuously.
Panel lights
Power(Green)
The POWER light is on whenever the printer is on.
ERROR(Red)
POWER
ERROR
FEED
10
1-7. Adjustments and Settings
The STP131 Series is set up at the factory to be appropriate for almost all users.
It does, however, offer some settings for users with special requirements.
It has DIP switches that allow you to change communication settings, such as
handshaking and parity check, as well as print density.
Ths STP131 Series also has a near-end sensor for the paper. This can give you a
warning when the paper is almost out. If you find that there is not enough paper
remalining on the roll when the paper low is triggered, the Error LED(Red) is turn on.
1) The error LED blinks fast when paper is out.
2) The error LED blinks when the Near End Sensor triggered.
