17
When you’re ready to charge your battery, it is vital that you use only Sprint PCS-approved desktop
chargers and travel chargers. To use the desktop charger provided with your phone:
1.
Plug the power cord of the charger into a wall outlet.
2.
There are three possible charging configurations.
Choose the one that best suits your needs:
_
Insert the phone (with the battery installed) into the front slot of the charger.
_
Insert a single battery (alone, not attached to the phone) into the rear compartment of the charger.
_
Insert a single battery into the rear compartment and your phone (with battery attached) into the
front compartment.
The LEDs on the front of the charger indicate the following:
_
A
red light
on the charger lets you know the battery is charging.
_
A
green light
lets you know that the battery is at least 90 percent charged.
_
A
yellow light
indicates that the battery is operating at a temperature that is too high or too low, or
that there is a poor connection. Check the phone to make sure it is properly positioned in the charger.
It generally takes about 3 hours to fully recharge a completely discharged battery. With the Sprint
PCS-approved Lilon battery, it is okay to recharge the battery before it becomes completely run
down.
To get the quickest charge for any battery:
_
Turn the phone off.
_
Put the phone with the battery attached, into the front slot of the charger.
_
Do not put a battery into the rear slot of the charger.
_
When two batteries are in the charger, the batteries charge simultaneously, but charging time
increases for both batteries.
_
Leaving batteries in the charger once fully charged will not hurt the batteries.
Entering Text
4