Installation and Connection
2-6
Install a new lamp in the reverse order of removal.
Replacing and Cleaning the Filter
Precautions when replacing the projector filter:
•
The filter is on the side of the projector.
•
Turn off the power of the projector, and then disconnect the power cord after the projector has cooled sufficiently.
Otherwise, its parts may be damaged due to internal heat.
•
When you replace the filter, you may release some dust.
•
For inquiries on replacement filter purchase, please see 'Contact SAMSUNG WORLDWIDE' in Chapter 5.
To replace or clean the filter, follow these steps:
1.
Turn off the power of the projector, and then disconnect the power cord after the projector has cooled sufficiently.
2.
Open the filter cover.
3.
Replace or clean the filter.
•
When cleaning the filter, use a small vacuum cleaner designed for computers and small electronics products, or wash it under
running water.
•
After washing the filter under running water, make sure to dry it completely. The moisture may cause the filter to corrode.
•
If dust cannot be separated from the filter or the filter is torn, it must be replaced.
•
After cleaning or
replacing the filter, run <Reset> -
> <Reset Filter Time>
in the
<Setup>
menu.
Ventilation openings
For the location of the ventilation openings, see the picture below:
•
Do not block the ventilation openings. Blocking the ventilation openings can cause your projector to overheat and may cause
it to fail.
Air outtake vent
Air intake vent
