6.9
5.5
4.1
9.2
30.1
7.1
5.7
4.3
9.6
31.4
7.4
5.9
4.4
9.9
32.4
7.6
6.1
4.6
10.2
33.4
2. Select one from
Front-Floor
,
Front-Ceiling
,
Rear-Floor
and
Rear-Ceiling
according to the location to install the projector.
3. Set the values of the
H-Keystone
and the
V-Keystone
to '0' and place the zoom knob right in the middle of its movement range.
4. Press the
MENU
button to display the
Crosshatch
screen of the
Test Pattern
.
(
Setup
→
Test Pattern
→
Crosshatch
)
5. Adjust the location of the projector until lines
①
and
②
in the picture below become parallel.
Screen
Crosshatch
Test Pattern
①
A virtual vertical line made on the screen using a piece
of thread, etc.
②
A vertical line in the middle of the
Test Pattern
6. Adjust the projector's angle so that a corner of the projected picture (which is nearest to the projector) meets that of the screen.
A : Projector
B : Screen
C : Projected image
D : A corner of the picture nearest to
the projector
→
Adjust the projector's angle until the projected image covers the entire screen area
(The projected image may not cover the entire screen area depending on the projector's installation height. In this case, adjust the
projector's angle so that the entire screen area can be covered.)
7. Press the V.KEY-STONE button on the remote control. The
V-Keystone
menu will be displayed.
Adjust
V-Keystone
using the + or - button on the remote control.
- A : Projector - B : Screen - C : Projected image