86
(2) If LED of Network for SNS-110 is working correctly, the values for Network within SNS-110 might have
been incorrectly entered. In such a case, refer to Supplement B Factory Default to turn the settings to
the factory mode. Then, retry setting the IP address again, as shown in Chapter 4.
The PC to setup the IP Address at SNS-110 must use the IP Address that has the same network as the
IP Address to setup at SNS-110.
For example, the IP Address you want to be authorized with SNS-110 is 168.219.15.212, the PC that is
used for setting up IP Address through arp, ping should be 168.219.15.XX. That means it should have
the same network class (168.219.15).
In case the same Network Addresses cannot be authorized, use Hyper Terminal to setup IP Address.
When connections to SNS-110 cannot be established, after
connected to Cable Network
(1) See if the cable modem between cable network and SNS-110 is working correctly.
Contact the cable modem supplier.
(2) If it works on Ethernet but does not under cable network mode, re-set the value of network in
Administration mode to "YES" and disconnect it from Ethernet and install cable network.
If you try to connect cable network to Ethernet with the value "NO", you cannot obtain an IP address, so
you will not be able to establish a connection. In such a case, RS-232C's Terminal Emulation (Hyper
Terminal) should be used in re-setting the value. Refer to Supplement C, How to Use Console.
(3) If none of the above works, refer to Supplement B to set the values back to the factory mode and install
Cable Network.
If you wish to check the IP Address under auto-set IP address
environment
(1) Under the network condition of DHCP server using Cable Network or Ethernet, install SNS 110 and turn
the SNS-110 power on, then you will be given with an IP address from DHCP Server. This will auto-set
the information for SNS-110's network information.
(2) Set the SNS-110 and peripheral PC's RS-232C cable to SNS-110's IP address, then refer to
Supplement
C How to Use Console to check the network information.
(3) Note that a new IP addresses will be given every time you turn the power on for SNS-110 under auto-set
IP Address.
(4) If you wish to receive a fixed IP address under the auto-set IP address environment through Ethernet,
you may contact the manager and have an IP address fixed to your connection by registering your IP
address and Ethernet address.
(5) When you connected SNS-110 with Cable Modem, it’s easy to manage the assigned IP Address if you
use the method using Administration server explained earlier.
Summary of Contents for SNS-110
