Samsung SMH1622B/XAA, Installation Instructions Manual

Page: 14 / 20

Installation Instructions
14
C.
OUTSIDE BACK EXHAUST
(HORIZONTAL DUCT)
C1.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE BACK
EXHAUST
1.
Remove and save screw that holds blower Plate
to microwave.
3.
Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the
blower is removed and re-installed.
4.
Rotate blower unit counterclockwise 180°.
5.
Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of microwave
oven.
6.
Close the blower plate and attach the exhaust
adaptor to the rear of the oven by sliding it into the
guides at the top center of the back of the oven.
Push in securely until it is in the lower locking
tabs. Take care to assure that the damper hinge is
installed so that it is at the top and that the
damper swings freely.
Screw
Back of
Microwave
Blower Motor
2.
Lift up the Blower Plate.
Blower Plate Screw
End A
End B
BEFORE: Fan Blade
Openings Facing Forward
Before Rotation
Back of
Microwave
Back of
Microwave
After Rotation
End A
End B
AFTER: Fan Blade
Openings Facing Back
Guide
Back of
Microwave
Adaptor
Guide
From Blower motor screw
(after attached the exhaust adaptor)
blower plate screw