ENGLISH
17
Problem
When the MPEG software
plays a Video CD, the
pictures are not regular and
the running speed is too slow.
Adjust the size of the replay screen.
The Disc is not in message is
displayed even though a disc
has been inserted.
The computer may not recognize the disc if you
start playback too quickly after inserting the disc.
Open and close the disc compartment and try again.
The COMBO drive is not
detected after it is connected
to a sound card.
The interface mode of the sound card is AT-BUS.
You must therefore connect the COMBO drive to
the IDE port on the PC mother board, rather than
to the sound card, or install an E-IDE compatible
sound card.
Clean the disc and try again.
After checking the display resolution, adjust it,
if necessary.
Meaning / Solution
Solving Technical Problems
16
Problem
The COMBO drive is not
detected by the computer.
After installing the COMBO
drive, the PC gets slower.
Check that the power, audio and IDE cables are
correctly connected to the computer.
Change the IDE cable and reconnect it to the
computer.
Preferably, connect a second IDE cable to the
COMBO drive in master mode.
Meaning / Solution
The COMBO drive is not
recognized by MS-DOS.
Reinstall the device driver or update it with the
latest version by downloading it from the
Samsung Web site.
- www.samsungodd.com
- www.samsungelectronics.com
The COMBO drive is not
detected by Windows.
This case may occur when there is a Windows
installation problem; reinstall Windows.
No sound is heard from an
audio CD.
Check whether the audio cable is correctly
connected to the sound output terminal on the
COMBO drive and the sound card CD-IN terminal.
A CD is not read or is read
too slowly.
Check whether the CD is of good quality and clean it,
if necessary.
The disc compartment will
not open.
Check that the power cable is correctly connected.
Power off and disconnect the PC.
Insert a pin or unfolded paper clip in the emergency
hole and push firmly until the disc compartment opens.
Check that the sound card is operational.
Adjust the volume control.
Run the CD player supplied with Windows or your
sound card.
You can listen to the CD by connecting headphones
to the appropriate connector.
If you have installed the appropriate player, such as
Microsoft Windows Media Player, you can adjust the
volume using the headphone volume control on the
drive front panel.
If you select DIGITAL at CD Audio Play in Media
Player of Windows ME/XP, the earphone does not
appear in the Digital Mode.
Check the position of the jumper in the master/slave
select terminal.
