Samsung SLIM DUCT Series, Service Manual

Page: 33 / 64

Samsung Electronics 4-9
Setting an indoor unit installation option
In order to check and set the indoor unit installation option code use the wired remote controller and follow
the directions below.
1) Press the and buttons at the same time for more than 3 seconds and then a Main menu will be
displayed.
2) Press the / button to select and then press button to enter a Sub-menu setting screen.
3) Press the / button to select and then press button to enter a Indoor unit installation option code
setting screen.
4) Press the / button to set the installation option code in order. Press button to go to the next page.
SGE1 SGE2 SGE3 SGE4 SGE5 SGE6
0 2 RESERVED
Exterior
temperature
sensor
Central control RESERVED
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 Drain pump RESERVED RESERVED RESERVED Master / Slave
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 External control
External control
output
Virus doctor Buzzer
Number of hours
using filter
SEG19 SEG20 SEG21 - - -
3
Individual control
of a remote
controller
Heating setting
compensation
- - -
t The first digit represents the page number and the remaining five digits are installation option.
t
The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page
number (0, 1, 2, 3).
NOTE