95
Phone Settings
94
Phone Settings
SIM Lock
When the SIM Lock feature is enabled, your
phone only works with the current SIM. You
must enter the SIM lock code.
Once you have entered the lock code, you are
asked to confirm it by entering it again.
To unlock the SIM, you must enter the SIM lock
code.
FDN Mode
The FDN (Fixed Dial Number) mode, if supported
by your SIM card, allows you to restrict your
outgoing calls to a limited set of phone numbers.
The following options are available:
Disable: you can phone any number.
Enable: you can only call phone numbers stored
in the Phonebook. You must enter your PIN2.
Note: Not all SIM cards have a PIN2. If your SIM
card does not, this menu option is not
displayed.
To change your PIN2, refer to the Change PIN2
menu option (Menu 4.6.7) below.
Change PIN2
The Change PIN2 feature allows you to change
your current PIN2 to a new one. You must enter
the current PIN2 before you can specify a new
one.
Once you have entered a new PIN2, you are
asked to confirm it by entering it again.
Note: Not all SIM cards have a PIN2. If your SIM
card does not, this menu option is not
displayed.
Display Settings
(Menu 4.7)
Contrast
This option allows you to adjust the contrast of
the display screens to make them lighter or
darker.
To adjust the display contrast:
1. Select the required display Main LCD or
Front LCD, and press the Select soft key.
2. Adjust the contrast by using the
and
keys or the and
keys on the left side of
the phone.
3. When you are satisfied, press the OK soft key
to save the selection.
Back Light
You can select whether or not the phone uses
the backlight. A marginal increase in
standby/talk time can be achieved by turning the
backlight off.
Select the length of time for which the backlight
is on. The backlight comes on when you press a
key or receive a call or message and lights up
for the specified length of time. Then it dims and
finally switches off after the specified length of
time. 15 seconds, 30 seconds, 1 minute, 3
minutes and 10 minutes are available.
If you do not want to use the backlight, select
Off.