SAMSUNG Proprietary-Contents may change without notice
SGH-P408 Circuit Description
2-
8
This Document can not be used without Samsung's authorization
charging(CHG_DET, CHG_STAT0), SIM_RESET and FLIP_SNS with which we
knows open.closed status of folder. It has JTAG control pins(TDI/TDO/TCK) for
ARM core and DSP core. It recieves 13MHz clock in CKI pin from external
TCXO and receives 32.768KHz clock from X1RTC. ADC(Analog to Digital
Convertor) part receives the status of temperature, battery type and battery
voltage. And control signals(DSP_INT, DSP_IO and DSP_RWN) for DSP core are
used. It enables main LCD and small LCD with DSP IP pins.
7) CSP1093
CSP1093 integrates the timing and control functions for GSM 2+ mobile
application with the ADC and DAC functions. The CSP1093 interfaces to the
trident, via a 16-bit parallel interface. It serves as the interface that connects
a DSP to the RF circuitry in a GSM 2+ mobile telephone. DSP can load 148
bits of burst data into CSP1093’
s internal register, and program CSP1093’
s
event timing and control register with the exact time to send the burst. When
the timing portion of the event timing and control register matches the internal
quarter-bit counter and internal frame counter, the 148 bits in the internal
register are GMSK modulated according to GSM 2+ standards. The resulting
phase information is translated into I and Q differential output voltages that can
be connected directly to an RF modulator at the TXOP and TXON pins. The
DSP is notified when the transmission is completed. For receiving baseband
data, a DSP can program CSP1093’
s event timing and control register with the
exact time to start receiving I and Q samples through TXIP and TXIN pins.
When that time is reached, the control portion of the event timing and control
register will start the baseband receive section converting I and Q sample
pairs. The samples are stored in a double-buffered register until the register
contains 32 sample pairs. CSP1093 then notifies the DSP which has ample time
to read the information out before the next 32 sample pairs are stored. The
voice band ADC converter issues an interrupt to the DSP whenever it finishes
converting a 16-bit PCM word. The DSP then reads the new input sample and
simultaneously loads the voice band output DAC converter with a new PCM
output word. The voice band output can be connected directly to a speaker via
AOUTAN and AOUTAP pins and be connected to a Ear-mic speaker via
AOUTBN and AOUTBP pins.
8) X-TAL(13MHz)
This system uses the 13MHz TCXO, TCO-9141B, Toyocom. AFC control signal
form CSP1093 controls frequency from 13MHz x-tal. It generates the clock
frequency. This clock is fed to CSP1093,Trident,YMU759 and Silab solution.
