![background image](http://html.mh-extra.com/html/samsung/sgh-d500/sgh-d500_service-manual_1190461007.webp)
SAMSUNG Proprietary-Contents may change without notice
Circuit Description
This Document can not be used without Samsung's authorization
2-3
4. Key
This is consisted of key interface pins KEY_ROW(0:4) and KEY_COL(0:4) in PCF5213EL1. These signals compose the
matrix. Result of matrix informs the key status to key interface in the PCF5213EL1. Power on/off key is seperated from
the matrix. So power on/off signal is connected with PCF50603 to enable PCF50603. Key LED is consisted of
six white
LEDs for sub key and twelve white LEDs for main key. White LED for sub key use the VBAT voltage.
"SLIDER_KEY_ON" signal enables Transistor for sub key backlight.
Main key LED use the
3.3V LDO for a supply voltage. KEY_LED_ON signal enables eight white LED.
"FLIP" informs the status of slide (open or closed) to the PCF5213EL1. This uses the hall effect IC, A3212ELH.
A magnet under LCD enables A3212ELH.
5. EMI ESD Filter
This system uses the EMI ESD filter, U500 to protect noise from IF CONNECTOR part.
6. IF connetor
It is 18-pin connector. They are designed to use VBAT, V_EXT_CHARGE, USB_D+, +VBUS, USB_D-, TXD1, RXD1,
AUX_ON, EXT1, EXT2, HFK_SPK, HFK_MIC and GND. They connected to power supply IC, microprocessor and signal
processor IC.
7. Battery Charge Management
A complete constant-current/constant-voltage linear charger for single cell lithium-ion batteries.
If TA connected to phone, "V_EXT_CHARGE" enable charger IC and supply current to battery.
When fault condition caused, "CHG_ON" signal level change low to high and charger IC stop charging process.
8. Audio
HFR_P and HFR_N from PCF5213El1 are connected to the main speaker via analog switches. MIC_P and MIC_N
are connected to the main MIC as well. EAR1 is the source of External Speaker. YMU765 is a synthesizer LSI for
mobile phones. This LSI has a built-in speaker amplifier for outputting sounds that are used by mobile phones in addition
to game sounds and ringing melodies that are replayed by a synthesizer.
The synthesizer section adopts
“
stereophonic hybrid synthesizer system
”
that are given advantages of both FM
synthesizers and Wave Table synthesizers to allow simultaneous generation of up to 32 FM voices and 32 Wave
Table voices.
It provides simultaneous generation of up to 64 tones by stereophonic hybrid synthesizer.
YMU765 has built a speaker amplifier of which maximum out is 580 mW at SPVDD=3.6V in this device.
There is Stereophonic analog output for Headphone.
9. Memory
This system uses Samsung's memory, KBJ10KB00M. The KBJ10KB00M is a Multi Chip Package Memory which
combines 256Mbit Synchronous Burst Multi Bank NOR Flash Memory and two 512Mbit OneNAND Flash and
128Mbit Synchronous Burst U tRAM.
It has 16 bit data line, HD[1~16] which is connected to PCF5213 and MV319, also has 24 bit address lines,
HA[1~24]. There are 3 chip select signals, CS0n_FLASH, CS4n_NAND, and CS1n_RAM.
In the Wrting process, WEn is fallen to low and it enables writing process to operate. During reading process,
OEn is fallen to low and it enables reading process to operate. Each chip select signals in the PCF5213 choose
different memories.